Shandong Hengyang New Materials | Geosynthetics plant, Dezhou Geomembrane · Geotextile · Composite liner · GCL Hotline +86 156 8951 2579(Mr. Zhang) 中文EN
INSIGHTS · industry

Seam testing: air pressure, vacuum or spark test

2026-11-17 · Written by Hengyang Technical Department · Reviewed by Zhang (engineering procurement) · Sources: current standards and batch test reports

Standard answer summary

Each method has a job: air pressure checks the dual-track channel, vacuum checks single seams and details, s. Maintained by the Hengyang technical department; values follow the current standard, design document and batch report. Call +86 156 8951 2579 (Mr. Zhang).

Source: Hengyang technical department | Updated: 2026-11-20

For dual-track hot wedge seams, use air pressure: seal both ends, charge to the specified pressure and watch the drop. A rapid drop means a channel and the seam must be located and repaired.

Use vacuum testing for single seams, pipe penetrations, anchor details and repairs. Soap solution plus vacuum shows a leak as continuous bubbles; hold the vacuum long enough.

Spark testing is fast over large areas but needs a conductive subgrade and moisture. It finds holes; it does not replace seam continuity or strength testing.

Related materials and scenarios

What air pressure is used?

Follow the current standard and equipment data, commonly starting at 0.15–0.2 MPa; the project acceptance rule governs.

How is a leak repaired?

Clean the area, apply a patch, weld the full patch edge, then retest the patch and original seam; record the repair.

Send us your project conditions

We reply with datasheets, test reports and a quotation within one business day.

Request a quotationEmail us
Call Top