Shandong Hengyang New Materials | Geosynthetics plant, Dezhou Geomembrane · Geotextile · Composite liner · GCL Hotline +86 156 8951 2579(Mr. Zhang) 中文EN
INSIGHTS · industry

Anchor trench: size, backfill and slope fixing

2026-11-15 · Written by Hengyang Technical Department · Reviewed by Zhang (engineering procurement) · Sources: current standards and batch test reports

Standard answer summary

An anchor trench is not a hole with membrane buried in it. Maintained by the Hengyang technical department; values follow the current standard, design document and batch report. Call +86 156 8951 2579 (Mr. Zhang).

Source: Hengyang technical department | Updated: 2026-11-20

Place the trench outside the slope crest failure zone, usually at a stable crest or toe. Lay the membrane to the trench bottom with enough reserve.

Backfill in compacted layers, not one dump. Do not place rock or brick directly on the membrane; use sand or fine soil protection where needed.

The trench must drain. Standing water reduces friction and compaction; in cold regions, freeze-thaw also matters.

Related materials and scenarios

How wide and deep is an anchor trench?

Commonly 0.3–0.5 m wide and 0.5–0.8 m deep, adjusted to design and membrane thickness.

How much membrane goes into the trench?

Follow the design, usually at least 0.5 m anchorage length; add length for high slopes and exposed liners.

Send us your project conditions

We reply with datasheets, test reports and a quotation within one business day.

Request a quotationEmail us
Call Top